Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Blower resistor

On-vehicle inspection

  1. Inspect blower motor control

Toyota RAV4. Inspect blower motor control


  1. Measure the resistance of the blower resistor.

Standard resistance


If the resistance is not as specified, replace the blower motor control.

Blower motor
On-vehicle inspection Inspect blower motor (for automatic air conditioning system) Disconnect the blower motor connector. Connect the positive (+) lead from the battery to terminal 1 ...

Air inlet control servo motor
Components Removal Remove blower assembly Remove the blower (see page ac-203). Remove air inlet control servo motor (see page ac-210) Inspection Inspect air inlet control ...

Other materials:

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove accelerator pedal rod Disconnect the accelerator pedal position ...

Insufficient coolant temperature for closed loop fuel control
Description Refer to dtc p0115 (see page es-105). Monitor description The resistance of the ect sensor varies in proportion to the actual ect. The ect supplies a constant voltage to the sensor and monitors the signal output voltage of the sensor. The signal voltage output varies acc ...

Gcwr, twr and unbraked twr
Confirm that the gross trailer weight, gross combination weight, gross vehicle weight, gross axle weight and tongue weight are all within the limits. Gcwr* 2Wd models: 5985 lb. (2715 Kg) Awd models: 6100 lb. (2765 Kg) Twr* 1500 Lb. (680 Kg) Unbraked twr* 1000 Lb. (450 Kg) *: ...

В© 2011-2026 Copyright www.trav4.net