Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Front console illumination

On-vehicle inspection

Toyota RAV4. Front console illumination


  1. Inspect front console illumination

  1. Connect the battery's positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, then check that the light comes on.

Ok: light comes on.

If the result is not as specified, replace the front console illumination.

Vanity light
Components Removal Hint: Use the same procedures for the rh and lh sides. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Cautio ...

Footwell light
On-vehicle inspection Inspect footwell light Connect the battery's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1, then check that the light comes on. Ok: ...

Other materials:

A/f sensor circuit slow response (bank 1 sensor 1)
Hint: Sensor 1 refers to the sensor mounted in front of the three-way catalytic converter (twc) and located near the engine assembly. Description Refer to dtc p2195 (see page es-292). Monitor description After the engine is warmed up, the ecm performs air-fuel ratio feedback contro ...

Power outlets
The power outlet can be used for 12 v accessories that run on less than 10 a. Open the lid. The power outlets can be used when Vehicles without a smart key system The engine switch is in the “acc� or “on� position. Vehicles with a smart key system The engine switch is in ...

Only driver door lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Perform active test by intelligent tester (door lock) Select the active test, use the intelligent tester to generate a control c ...

© 2011-2026 Copyright www.trav4.net