Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: 2Az-fe charging

Installation
Install ignition switch assembly Install the ignition switch with the 2 screws. Install the ignition key cylinder light connector. Install the ignition switch connector. ...

Charging system
...

Other materials:

If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s battery is discharged. You can also call your toyota dealer or a qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt battery, you can jump start your vehicle by fo ...

Battery current sensor circuit
Description The battery current sensor installed on the positive (+) battery terminal detects the amount of current supplied from the generator. The battery current sensor changes current to voltage (at the positive (+) battery terminal) and sends it to the ecm. The ecm controls th ...

Operation check
Inspect driver side seat belt warning light Turn the ignition switch on. When the driver seat belt is not fastened, check that the driver seat belt warning light on the combination meter blinks. When the driver seat belt is fastened, check that the driver seat belt warning light o ...

© 2011-2026 Copyright www.trav4.net