Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Brake control

Parking brake system
Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected ...

Vehicle stability control system
...

Other materials:

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
Preconditions The monitor will not run unless: The mil is off. Drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the tester on. Clear dtcs (if set) (see page es-35). Start the engine. Allow the engine to idle for 10 minute ...

Customizing the startup and screen off images (if equipped)
An image can be copied from a usb memory and used as the startup and screen off images. When the engine switch is in the “acc� or “on� position (vehicles without a smart key system) or accessory or ignition on mode (vehicles with a smart key system), the initial screen will be displaye ...

Throttle / pedal position sensor / switch "A"
Hint: These dtcs relate to the throttle position (tp) sensor. Description The tp sensor is mounted on the throttle body, and detects the opening angle of the throttle valve. This sensor is a non-contact type. It uses hall-effect elements in order to yield accurate signals even in extrem ...

© 2011-2026 Copyright www.trav4.net