Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: How to proceed with troubleshooting

Hint:

  1. Vehicle brought to workshop


  1. Inspect battery voltage

Standard voltage: 11 to 14 v

If the voltage is below 11 v, recharge or replace the battery before proceeding.


  1. Check and clear dtc*


  1. Problem symptom confirmation

Result




  1. Symptom simulation


  1. Check communication function of controller area network (can)*

  1. Use the intelligent tester to check for normal functioning of the can communication system.
  1. Perform bus check (communication malfunction dtc).

Result




  1. Check for dtc*

Result




  1. Problem symptoms table

Result



  1. Overall analysis and troubleshooting

  1. Terminals of ecu (see page bc-41)
  2. Data list / active test (see page bc-52)


  1. Check for fluid leakage


  1. Repair or replace


  1. Confirmation test


End

System description
System description Hint: The skid control ecu forms a single unit with the abs and traction actuator. Abs (anti-lock brake system): the abs helps prevent the wheels from locking when t ...

Check for intermittent problems
Check for intermittent problems Hint: A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ecus can be detected by using the ecu data list fun ...

Other materials:

Seat heater switch
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove switch base (see page ip-18) Remove seat he ...

Disassembly
Caution: Wear protective gloves. Sharp areas on the seat frame (with adjuster) may injure your hands. Remove reclining power seat switch knob Using a screwdriver, detach the knob. Hint: Tape the screwdriver tip before use. Remove slide and vertical power seat switch knob ...

Reassembly
Bearing position Standard bearing position Install differential gear lube apply tube Install the apply tube and clamp to the transaxle housing with the bolt. Torque: 9.8 N*m (100 kgf*cm, 87 in.*Lbf) Notice: Make sure to insert the pipe to the stopper. Instal ...

В© 2011-2026 Copyright www.trav4.net