Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Engine unit

Installation
Install drive plate sub-assembly Clean the 8 bolts and 8 bolt holes. Apply adhesive to 2 or 3 threads of the 8 bolts. Adhesive: Toyota genuine adhesive 1342, three bond 1342 or equival ...

Components
...

Other materials:

Oxygen sensor circuit
Description In order to obtain a high purification rate of the carbon monoxide (co), hydrocarbon (hc) and nitrogen oxide (nox) components in the exhaust gas, a twc is used. For the most efficient use of the twc, the air-fuel ratio must be precisely controlled so that it is always close to ...

Data list / active test
Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester to the dlc3. Turn the igni ...

Removal
Table of bolt, screw and nut Hint: All bolts, screws and nuts relevant to installing and removing the instrument panel are shown along with their alphabet codes in the table below. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconne ...

В© 2011-2026 Copyright www.trav4.net