Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: U140f automatic transaxle

Toyota RAV4 (XA40) 2013-2018 Service Manual / U140f automatic transaxle

Traction control switch (for 2wd)
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent ai ...

Automatic transaxle system
...

Other materials:

Propeller shaft assembly
Components Removal Remove propeller shaft with center bearing shaft assembly Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft. Notice: During the removal, do not exert excessive force on the universal joint. When r ...

Installation
Install camshaft timing oil control valve assembly Apply a light coat of engine oil to the o-ring of the oil control valve. Install the oil control valve with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*Lbf) Notice: Make sure that the o-ring is not cracked or jammed. Co ...

Initialization
Zero point calibration Notice: Make sure that the front passenger seat is not occupied before performing the operation. Hint: Perform the zero point calibration and sensitivity check if any of the following conditions apply. The occupant classification ecu is replaced. Accessories ( ...

В© 2011-2026 Copyright www.trav4.net