Toyota RAV4 (XA40) 2013-2018 Service Manual: Front seat frame with adjuster
Inspection
- Inspect front seat frame with adjuster
- Check operation of the seat frame (slide motor).
- Check if the seat frame moves smoothly when the battery is connected to the slide motor connector terminals.
Ok 
If the result is not as specified, replace the seat frame with adjuster.
- Check operation of the seat frame (front vertical motor).
- Check if the seat frame moves smoothly when the battery is connected to the front vertical motor connector terminals.
Ok 
If the result is not as specified, replace the seat frame with adjuster.
- Check operation of the seat frame (lifter motor).
- Check if the seat frame moves smoothly when the battery is connected to the lifter motor connector terminals.
Ok 
If the result is not as specified, replace the seat frame with adjuster.
- Check operation of the seat frame (reclining motor).
- Check if the seat frame moves smoothly when the battery is connected to the reclining motor connector terminals.
Ok 
If the result is not as specified, replace the seat frame with adjuster.
Power seat switch
Inspection
Inspect front power seat switch
Measure the resistance between the terminals when
each switch is operated.
Standard resistance
Slide switch
Front vertical switch
Lif ...
Front power seat lumbar switch
Inspection
Inspect front power seat lumbar switch lh
Measure the resistance between the terminals when
the switch is operated.
Standard resistance
If the result is not as specified ...
Other materials:
Removal (2005/11-2006/01)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove front door scuff plate lh
Using a screwdriver, detach the 10 cla ...
Rear airbag sensor
Components
On-vehicle inspection
Check rear airbag sensor (vehicle not
involved in collision)
Perform a diagnostic system check (see page rs-
49).
Check rear airbag sensor (vehicle
involved in collision and airbag has not
deployed)
Perform a diagnostic system check ...
Dtc check / clear
Check dtc
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignition switch on and turn the intelligent
tester on.
Read the dtc by following the prompts on the
tester screen.
Hint:
Refer to the intelligent tester operator's manual for
further details.
...
