Toyota RAV4 (XA40) 2013-2018 Owners Manual: Receiving a call
When a call is received, the following screen is displayed together with a sound.
To answer the phone
Press the 
switch on the
steering
wheel or select 
.
To refuse a call
Press the 
switch on the
steering wheel or select 
.
To adjust the incoming call volume
Turn the “pwr vol” knob. You can also adjust the volume using the steering switches.
International calls
Received international calls may not be displayed correctly depending on the cellular phone in use.
Making a call
Once a bluetooth® phone is registered, you can make a call
using the following procedure:
Dialing
Display the phone screen.
Select the “dial pad” tab and enter a phone number.
To delet ...
Speaking on the phone
The following screen is displayed when speaking on the phone.
To adjust the call volume
Select “-” or “+”. You can also adjust the volume using the steering
switches or the volume knob. ...
Other materials:
Wheels
If a wheel is bent, cracked or heavily corroded, it should be
replaced. Otherwise, the tire may separate from the wheel or
cause a loss of handling control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are
equivalent to those removed in load capacity, diameter ...
Terminals of ecu
Check sliding roof drive gear subassembly (sliding roof ecu)
Disconnect the p6 ecu connector.
Measure the resistance and voltage of the wire
harness side connector.
Reconnect the p6 ecu connector.
Measure the voltage of the connector.
If the result is not as speci ...
Tc and cg terminal circuit
Description
Dtc output mode is set by connecting terminals 13 (tc) and 4 (cg) of the
dlc3. The dtcs are indicated
by the blinking of the tire pressure warning light.
Wiring diagram
Hint:
When each warning light continues blinking, a ground short in the wiring of
terminal tc of the dlc3 ...
