Toyota RAV4 (XA40) 2013-2018 Service Manual: 2Az-fe lubrication

Fuel tank

Components Removal Discharge fuel system pressure (see page fu-9) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cabl ...

Lubrication system

On-vehicle inspection Check engine oil level Warm up the engine, stop the engine and wait for 5 minutes. Check that the engine oil level is between the l and f marks of the oil dipstic ...

Other materials:

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove roof drip side finish moulding lh Remove the 2 roof drip moulding joint covers from the vehicle body. Remove the roof drip side finish moulding and no. 2 Center ...

Intake air temperature circuit malfunction
Description The intake air temperature (iat) sensor, mounted on the mass air flow (maf) meter, monitors the iat. The iat sensor has a built-in thermistor with a resistance that varies according to the temperature of the intake air. When the iat is low, the resistance of the thermist ...

Compressor and pulley (for 2gr-fe)
Components Removal Discharge refrigerant from refrigeration system (see page ac-172) Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensione ...