Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Adjusting the settings manually

  1. To adjust the fan speed, press   on
      to increase the fan
    speed and    to
    decrease the fan speed.

    Press  to turn the fan off.


  2. To adjust the temperature setting, turn  clockwise to
    increases the temperature and turn  counterclockwise to
    decreases the temperature.

The air conditioning system switches between individual and simultaneous modes each time is pressed.


Simultaneous mode (the indicator on  
is on): the driver’s side temperature control dial can be used to adjust the temperature for the driver’s and passenger’s side. At this time, operate the passenger’s side temperature control dial to enter individual mode.

Individual mode (the indicator on  
is off): the temperature for the driver’s and passenger’s side can be adjusted separately.

  1. To change the air outlets, press  or 
      on
    .

The air outlets used are switched each time either side the button is pressed.

Using the automatic air conditioning system
Press   . The dehumidification function begins to operate. Air outlets and fan speed are automatically adjusted according to the temperature setting and humidity. Turn   clockwis ...

Defogging the windshield
Press  . The dehumidification function operates and fan speed increases. Set the outside/recirculated air mode button to outside air mode if the recirculated air mode is used. (It may s ...

Other materials:

Headlight assembly
Components Removal Hint: Use the same procedures for the rh and lh sides. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Remove front fender liner lh (see page et-4) Remove front fender liner rh (see page et-4) Remove ra ...

If the engine will not start
If the engine will not start even though correct starting procedures are being followed („_p. 197, 200), Consider each of the following points: The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be ...

RCTA (Rear Cross Traffic Alert) function
The RCTA function uses the BSM rear side radar sensors installed behind the rear bumper. This function is intended to assist the driver in checking areas that are not easily visible when backing up. WARNING â– Cautions regarding the use of the system The driver is solely responsible for safe driving ...

© 2011-2026 Copyright www.trav4.net