Manual air conditioning
systemInstallation (2005/11-2006/01)
Install front drive shaft assembly lh
Coat the spline of the inboard joint shaft with gear
oil.
Using a brass bar and hammer, align the shaft
splines in the drive shaft.
Notice:
Set the snap ring with the opening side facing
downwards.
Be careful not to damage the oil s ...
Checking monitor status
Perform monitor drive pattern
Connect the intelligent tester to the dlc3.
Turn the ignition switch and the tester on.
Clear the dtcs (see page es-35).
Run the vehicle in accordance with the applicable
drive pattern described in readiness monitor
drive pattern (see page es-19). Do ...
Body
General maintenance
Tighten bolts and nuts
Tighten the bolts and nuts on the chassis parts listed
below, if necessary.
Front axle and suspension
Drivetrain
Rear axle and suspension
Brake system
Engine mounting
Other chassis parts
Tighten the bolts and nuts on the bo ...