Toyota RAV4 (XA40) 2013-2018 Owners Manual: Rear window and outside rear view mirror defoggers
These features are used to defog the rear window, and to remove raindrops, dew and frost from the outside rear view mirrors (if equipped).
Vehicles with a manual air conditioning system
On/off
The defoggers will automatically turn off after approximately 15 minutes.
- Vehicles with an automatic air conditioning system
On/off
The defoggers will automatically turn off after approximately 15 minutes.
Operating conditions
- Vehicles without a smart key system
The engine switch is in the “on” position.
- Vehicles with a smart key system
The engine switch is in ignition on mode.
The outside rear view mirror defoggers (vehicles with outside rear view mirror defoggers)
Turning the rear window defogger on will turn the outside rear view mirror defoggers on.
Caution
?When the outside rear view mirror defoggers are on (vehicles with outside rear view mirror defoggers)
Do not touch the rear view mirror surfaces, as they can become very hot and burn you.
Notice
To prevent battery discharge
Turn the defoggers off when the engine is off.
Adjusting the position of and opening and closing the air outlets
Front center outlets
Direct air flow to the left or
right, up or down.
Turn the knobs to open or
close the vents.
Turn the knob to open or
close the vent for rear seat
occupants.
...
Windshield wiper de-icer
This feature is used to prevent ice from building up on the windshield
and wiper blades.
On/off
The windshield wiper de-icer will
automatically turn off after approximately
15 minutes. Pressing t ...
Other materials:
Interior
SRS airbags
Floor mats
Front seats
Rear seats
Head restraints
Seat belts
Console box
Inside lock buttons
Cup holders
Assist grips
Rear seat heater switches*
*: If equipped
Ceiling
"SOS" button*1
Auxiliary box
Moon roof switches*1
Interior lights*2
Personal lights
Electronic sun ...
Power supply relay failure
Description
If the power steering ecu detects these dtcs, it shuts off the motor relay
circuit (built into the power
steering ecu) and stops power assist.
Inspection procedure
Reconfirm dtc
Check for dtc.
Ok:
dtc is not output.
Replace power steering ecu ...
Terminals of ecm
Check ecm
Measure the voltage of the ecm connector.
Hint:
Each ecm terminal's standard voltage is shown in
the table below.
In the table, first follow the information under
"condition". Look under "symbols (terminal no.)"
For the terminals to be inspected. ...
