Toyota RAV4 (XA40) 2013-2018 Owners Manual: Console box

Toyota RAV4 (XA40) 2013-2018 Owners Manual / Interior features / Using the storage features / List of storage features / Console box

Lift the lid while pulling up the lever to release the lock.

Toyota RAV4. Console box

When using the console box lid as an armrest (vehicles with slide function)

Slide the console box lid forward as needed. Pull the lid forward by holding the front of the lid.

Toyota RAV4. Console box

Caution

Console box adjustment precaution

Do not adjust the position of the console box while the vehicle is moving.

This may cause the driver to mishandle the vehicle and may lead to an accident that results in death or serious injury.
Be careful not to get hands or feet pinched between the front console box and the center panel or rear seats.
Be careful not to allow the front console box to hit any passengers while adjusting its position.
After adjusting the console box, make sure it is securely locked in position.

Glove box

Pull up the lever to open the glove box. Power back door main switch (if equipped) The power back door main switch is located in the glove box. ...

Cup holders

Front Rear Pull the armrest down. Adjusting the size of the cup holder (front passenger’s side) The adjuster can be removed. Caution Items unsuitable for the cup holders Do not pl ...

Other materials:

Cooling system
On-vehicle inspection Check cooling system for leaks Remove the radiator reservoir cap. Caution: To avoid the danger of being burned, do not remove the radiator reservoir cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to b ...

Brake pedal load sensing switch
Description The brake pedal load sensing switch is turned on when the brake pedal is depressed with force exceeding a predetermined level. The skid control ecu detects if the brake pedal is depressed or not via this circuit. Wiring diagram Inspection procedure Notice: When repla ...

Cooling fan motor
On-vehicle inspection Inspect no. 1 Cooling fan motor Disconnect the no. 1 Fan connector. Connect the battery and ammeter to the no. 1 Fan motor connector. Check that the no. 1 Fan rotates smoothly, and then check the reading on the ammeter. Standard amperage ...