Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Front bumper

Exterior
...

Components
...

Other materials:

Automatic transmission
Select the shift position depending on your purpose and situation. Shift position purpose and functions P - Parking the vehicle/ starting the engine R - Reversing N - Neutral D - Normal driving*1 S  - S mode driving*2 *1:Shifting to the D position allows the system to select a gear suitable for ...

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
Preconditions The monitor will not run unless: The mil is off. Drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the tester on. Clear dtcs (if set) (see page es-35). Start the engine. Allow the engine to idle for 10 minute ...

Transmission control cable assembly
Replacement Remove rear console box sub-assembly Remove the console box (see page ip-20). Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pre ...

В© 2011-2026 Copyright www.trav4.net