Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Heater relay

On-vehicle inspection

Toyota RAV4. On-vehicle inspection


  1. Inspect relay (marking: htr)

  1. Measure the resistance of the htr relay.

Standard resistance


If the result is not as specified, replace the relay.

Solar sensor (for automatic air conditioning system)
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent ai ...

Air conditioning control assembly (for automatic air conditioning system)
Components Removal Disconnect cable from negative battery terminal Notice: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent air ...

Other materials:

Components
...

Tc and cg terminal circuit
Description Dtc output mode is set by connecting terminals 13 (tc) and 4 (cg) of the dlc3. The dtcs are indicated by the blinking of the tire pressure warning light. Wiring diagram Hint: When each warning light continues blinking, a ground short in the wiring of terminal tc of the dlc3 ...

Rear wiper motor
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove back door center garnish (see page ed-59) ...

В© 2011-2026 Copyright www.trav4.net