Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

Toyota RAV4. Installation


  1. Install camshaft timing oil control valve assembly

  1. Apply a light coat of engine oil to the o-ring of the oil control valve.
  2. Install the oil control valve with the bolt.

Torque: 9.0 N*m (92 kgf*cm, 80 in.*Lbf)

Notice:

Make sure that the o-ring is not cracked or jammed.

  1. Connect the oil control valve connector.

Toyota RAV4. Installation


  1. Connect cable to negative battery terminal

  2. Check for engine oil leaks

  1. Start the engine, and check that there are no oil leaks.
  1. Install no. 1 Engine cover (see page es-414)

Inspection
Inspect camshaft timing oil control valve assembly Measure the resistance of the oil control valve. Standard resistance If the result is not as specified, replace the oil control valv ...

Camshaft position sensor
Components ...

Other materials:

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove radiator support opening cover Remove front wheel rh Remove no. 1 ...

Open in one side of can branch line
Description If 2 or more ecus and/or sensors do not appear on the intelligent tester's "bus check" screen via the can vim, one side of the can branch wire may be open. (One side of the canh [branch wire] /canl [branch wire] of the ecu and/or sensor is open.) Wiring diagram ...

Front wiper motor and link
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove front wiper arm head cap Remove the 2 c ...

В© 2011-2026 Copyright www.trav4.net