Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Camshaft timing oil control valve assembly

Toyota RAV4 (XA40) 2013-2018 Service Manual / 2Az-fe engine mechanical / Camshaft timing oil control valve assembly

Components

Toyota RAV4. Components


Installation
Install mass air flow meter Install the mass air flow meter with the 2 screws. Notice: Make sure that the o-ring is not cracked or jammed when installing it. Connect the mass air flo ...

On-vehicle inspection
Check camshaft timing oil control valve assembly Check the operation. Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the intelligent tester main ...

Other materials:

Diagnosis system
Check dlc3 The ecm uses iso 15765-4 for communication. The terminal arrangement of the dlc3 complies with sae j1962 and matches the iso 15765-4 format. If the result is not as specified, the dlc3 may have a malfunction. Repair or replace the harness and connector. Hint: Conn ...

Compressor solenoid circuit (2005/11-2006/01)
Description In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier. Based on this signal, the compressor changes the degree of refrigerant compression. Wiring diagram Inspection procedure Read value of intelligent ...

Cooling fan relay
On-vehicle inspection Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove engine room no. 2 Relay block cover Inspect ...

В© 2011-2026 Copyright www.trav4.net