Toyota RAV4 (XA40) 2013-2018 Owners Manual: Opening the back door from outside the vehicle
Back door opener
- Vehicles without a power back door
Raise the back door while
pressing up the back door
opener switch. 
- Vehicles with a power back door
When the back door is unlocked: press the back door opener switch.
When the back door is locked (vehicles with a smart key system): while carrying the electronic key on your person, press the back door opener switch.
Pressing the switch while the back door is opening/closing stops the operation.
Wireless remote control (vehicles with a power back door)
Back door
The back door can be locked/unlocked and opened/closed by
the following procedures.
Locking and unlocking the back door
Door lock switch
Entry function (if equipped)
Wireless remote control
...
Power back door switch (vehicles with a power back door)
Pressing the switch closes the
back door automatically. (A
buzzer sounds.)
Pressing the switch while the back
door is opening/closing stops the
operation. Pressing the switch
again will reverse ...
Other materials:
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Install no. 2 Seat leg box protector
Attach the clip to install the protector.
Install the clip.
Install rear no. 1 Floor mat support side plate
Install rear no ...
Antenna coil open / short
Description
The transponder key coil receives key code signals from the transponder chip
in the key grip. The coil
built into the transponder key amplifier amplifies the key code signals and
outputs the signal to the
transponder key ecu.
Wiring diagram
Inspection procedure
R ...
Check mode procedure
Check mode (signal check)
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignition switch on.
Select the "signal check", and continue
checking with the intelligent tester.
Notice:
Select the "signal check" from the "dtc
check&quo ...
