Toyota RAV4 (XA40) 2013-2018 Service Manual: Operation check
- Check key reminder warning system
- Check that the key reminder warning buzzer sounds.
- With the driver side door closed, insert the key into the ignition key cylinder and then turn the ignition switch to lock or acc.
- Check that the buzzer sounds intermittently when the driver side door is open.
- Check that the key reminder warning buzzer stops.
- Check that the buzzer stops sounding if any of the following operations is performed while the buzzer is sounding:
- Close the driver side door (front door courtesy light switch is off).
- Turn the ignition switch on.
- Remove the key from the ignition key cylinder.
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the key reminder
warning system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column
of th ...
Other materials:
Data list / active test
Hint:
Using the intelligent tester's data list allows switch, sensor,
actuator and other item values to be read without removing
any parts. Reading the data list early in troubleshooting is
one way to save time.
Data list for occupant classification ecu
Connect the intelligent test ...
If your vehicle has to be stopped in an emergency
Only in an emergency, such
as if it becomes impossible
to stop the vehicle in the
normal way, stop the vehicle
using the following procedure:
Stopping the vehicle
1. Steadily step on the brake
pedal with both feet and
firmly depress it.
Do not pump the brake pedal
repeatedly as this will increase t ...
Transmission fluid temperature sensor "A" circuit
Description
The automatic transmission fluid (atf) temperature sensor converts the atf
temperature into a
resistance value which is input into the ecm.
The ecm applies a voltage to the temperature sensor through ecm terminal tho1.
The sensor resistance changes with the atf temperature. ...
