Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Refrigerant

Ig power source circuit
Description This is the main power source supplied to the air conditioning amplifier when the ignition switch is on. This power source is used for operating components, such as the air condition ...

On-vehicle inspection
Inspect refrigerant pressure with manifold gauge set This method uses a manifold gauge set to locate problem areas. Read the manifold gauge pressure when these conditions are establishe ...

Other materials:

Ignition key cylinder light
Components Removal Disconnect cable from negative battery Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Place front wheels facing straight ahead Remove steering pad ...

Diagnostic trouble code chart
Hint: Parameters listed in the chart may be different than your readings depending on the type of instrument and other factors. If any dtcs are displayed during a check mode dtc check, check the circuit for the dtcs listed in the table below. For details of each dtc, refer to the page indica ...

Monitor drive pattern
Test monitor drive pattern for ect Caution: Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving. Hint: Performing this drive pattern is one method to simulate the ect's malfunction detection conditions. The dtcs may ...

В© 2011-2026 Copyright www.trav4.net