Opening the fuel tank cap
Perform the following steps to open the fuel tank cap:
Rear window wiper
and washer
Before refueling the vehicleTransmitter id not registered in main mode
Description
Inspection procedure
Notice:
It is necessary to register an id code after replacing the tire pressure
warning valve and
transmitter and/or the tire pressure monitor ecu (see page tw-9).
Hint:
Set the tire pressure to the specified value.
Standard pressure:
220 kpa (2.2 ...
Removal
Hint:
When removing the spoiler, heat the vehicle body and spoiler
using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and spoiler excessively.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
...
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator and other item values to be read without
removing any parts. Reading the data list early in
troubleshooting is one way to save time.
Connect the intelligent tester to the dlc3.
Turn the igni ...