Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

  1. Drain engine coolant (see page co-6)

  2. Disconnect cable from negative battery terminal

Caution:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Remove air cleaner cap (see page es-411)

  2. Remove air cleaner case (see page es-429)

  3. Remove engine coolant temperature sensor

Toyota RAV4. Removal


  1. Disconnect the sensor connector.
  2. Using sst, remove the sensor and gasket.

Sst 09817-33190

Engine coolant temperature sensor
Components ...

Inspection
Inspect engine coolant temperature sensor Measure the resistance of the sensor. Standard resistance Notice: If checking the sensor in water, be careful not to allow water to contac ...

Other materials:

Check and replace ecu
Notice: The connector should not be disconnected from the ecu. Perform the inspection from the backside of the connector on the wire harness side. When no measuring condition is specified, perform the inspection with the engine stopped and the ignition switch on. Check that the con ...

Short in front driver side - side squib circuit
Description The driver side - side squib circuit consists of the center airbag sensor and the front seat side airbag lh. This circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in the driver side - side sq ...

Front passenger side - side airbag sensor circuit malfunction
Description The side airbag sensor rh consists of parts including the diagnostic circuit and the lateral deceleration sensor. When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the srs should be activated. Dtc b1625/22 i ...

В© 2011-2026 Copyright www.trav4.net