Toyota RAV4 (XA40) 2013-2018 Service Manual: Input signal circuit abnormal
Description
This dtc expresses the internal abnormalities of the ecm.
Inspection procedure
- Check for dtc
- Clear the dtc (see page cc-15).
- Check for dtc (see page cc-15).
Ok: dtc is not output.
End
Stop light switch circuit
Description
While driving with the cruise control, if the ecm detects that the brake
pedal is depressed, the cruise
control operation will be canceled. The stop light switch sends brake pedal ...
Brake system malfunction
Description
This dtc is output when the vsc system has a problem. Check the vsc system
when this dtc is
output.
Inspection procedure
Hint:
This circuit uses can communication. Therefore ...
Other materials:
On-vehicle inspection
Notice:
Perform the maf meter inspection according to the
procedures below.
Only replace the maf meter when both the long
ft#1 value and maf value in the data list (with the
engine stopped) are not within the normal operating
range.
Inspect mass air flow meter
Perform c ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove steering column cover lower
Detach the 4 claws, release the ...
Downhill assist control operation switch (test mode dtc)
Description
The downhill assist control switch is connected to the skid control ecu in
the abs and traction
actuator.
Dtc c1379/74 can be detected when the downhill assist control switch sends the
downhill assist control
switch signal or test mode ends. Dtc c1379/74 is output only in t ...
