Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Cruise control

Brk relay
On-vehicle inspection Inspect brk relay Remove the brk relay from the engine room no. 1 Relay block. Measure the resistance of the relay. Standard resistance If the result is no ...

Cruise control system
...

Other materials:

Position initialization incomplete
Description This dtc is output when the sliding roof drive gear (sliding roof ecu) has not been initialized. Wiring diagram Refer to dtc b2341 (see page rf-11). Inspection procedure Initialize sliding roof drive gear sub-assembly (sliding roof ecu) Check that the sliding roof ...

Short in front passenger side - side squib circuit
Description The front passenger side - side squib circuit consists of the center airbag sensor and the front seat side airbag rh. The circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in the front passenge ...

Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Install rear door belt moulding assembly lh Attach the claws to install the moulding. Hint: Confirm that the moulding is firmly installed. Install rear door tr ...

В© 2011-2026 Copyright www.trav4.net