Toyota RAV4 (XA40) 2013-2018 Service Manual: Unmatched encryption code
Description
This dtc is output when a key with an incomplete key code is inserted into the ignition key cylinder.
Inspection procedure
- Reregister key
- Clear the dtc (see page ei-18).
- Reregister the key code with the transponder key ecu (see page ei-5)
- Check that the engine starts with the key.
Ok: engine starts.
End
Transponder chip malfunction
Description
This dtc is output when: 1) during key code registration, a key malfunction
occurs; 2) the key code was
unable to be registered properly.
Inspection procedure
Reregister k ...
Unmatched key code
Description
This dtc is output when a key code that has not been registered in the
transponder key ecu is inserted
into the ignition key cylinder.
Inspection procedure
Reregister key
...
Other materials:
Yaw rate and deceleration sensor
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove front seat assembly lh
For manual seat: ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove front seat assembly lh
Remove the front seat.
For manual sea ...
Components
...
