Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Engine immobiliser

Door control receiver
Components Removal Remove rear door scuff plate rh Using a screwdriver, detach the 9 claws. Hint: Tape the screwdriver tip before use. Using a clip remover, ...

Engine immobiliser system
Parts location System diagram ...

Other materials:

Releasing and stowing the seat belt (for the rear center seat)
To release the hooked buckle “bâ€�, push the buckle release button. Release button To release the hooked plate A insert the mechanical key  Or plate B or the wireless key into the hole on the buckle. When releasing the seat belt, retract it slowly. Stow th ...

Valve body assembly
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove no. 1 Engine under cover Drain automati ...

Short in front passenger side pretensioner squib circuit
Description The front passenger side front pretensioner squib circuit consists of the center airbag sensor and the front seat outer belt rh. This circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in th ...

© 2011-2026 Copyright www.trav4.net