Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: For owners

Items to initialize
The following items must be initialized for normal system operation after such cases as the battery being reconnected, or maintenance being performed on the vehicle: ...

Reporting safety defects for u.S. Owners
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the national highway traffic safety administration (nhtsa) in a ...

Other materials:

Disassembly (2005/11-2006/01)
Remove front axle inboard joint boot no. 2 Clamp lh One touch type: Using a screwdriver, remove the no. 2 Inboard joint boot clamp, as shown in the illustration. Claw engagement type: Using needle-nose pliers, remove the no. 2 Inboard joint boot clamp, as shown in t ...

Inspection
Inspect rear stabilizer link assembly lh As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn. ...

Ig power source circuit
Description This is the main power source supplied to the air conditioning amplifier when the ignition switch is on (ig). This power source is used for operating components, such as the air conditioning amplifier and servo motors. Wiring diagram Inspection procedure Inspect fuse (ec ...

В© 2011-2026 Copyright www.trav4.net