Toyota RAV4 (XA40) 2013-2018 Owners Manual: General settings
Settings are available for adjusting the operation sounds, screen animation, etc.
Setup menu
You can adjust the audio system to your desired settings.
Display “setup” screen
Press the “setup” button to display the “setup” screen.
Select to adjust the settings for
operation ...
Screen for general settings
Press the “setup” button.
Select “general” on the “setup”
screen.
“English”, “français” or
“español” can be selected.
On/off can be selected to
...
Other materials:
Tc and cg terminal circuit
Description
Dtc output mode is set by connecting terminals tc and cg of the dlc3.
The dtcs are displayed by blinking the srs warning light.
Hint:
Make sure that dtc b1281 has not been output. If dtc b1281 has been
output, refer to the multiplex
communication system.
When each warning ...
Compressor circuit
Description
When the a/c switch is turned on, the magnetic clutch on signal is sent from
the air conditioning
amplifier. Then the mg clt relay turns on to operate the magnetic clutch.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (a/c mag clutch)
C ...
Settings display
Vehicle settings and the content
displayed on the screen can be
changed by using the meter
control switches.
■ Setting procedure
1. Operate or
of the
meter control switches and
select .
2. Operate or
of the
meter control switches and
select the desired item.
If the function is turned on and ...
