Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

  1. Install engine coolant temperature sensor

  1. Install a new gasket onto the sensor.
  2. Using sst, install the sensor.

Sst 09817-33190 torque: 19.6 N*m (200 kgf*cm, 14 ft.*Lbf)

  1. Connect the sensor connector.

Toyota RAV4. Installation


  1. Install air cleaner case (see page es-431)

  2. Install air cleaner cap (see page es-413)

  3. Connect cable to negative battery terminal

  4. Add engine coolant (see page co-6)

  5. Check for coolant leakage (see page co-1)

Inspection
Inspect engine coolant temperature sensor Measure the resistance of the sensor. Standard resistance Notice: If checking the sensor in water, be careful not to allow water to contac ...

Throttle body
Components ...

Other materials:

Towing related terms
â–  GCWR (Gross Combination Weight Rating) The maximum allowable gross combination weight. The gross combination weight is the sum of the total vehicle weight (including the occupants, cargo and any optional equipment installed on the vehicle) and the weight of the trailer being towed (including the ...

Pressure control solenoid "A " performance (shift solenoid valve sl1)
Description The ecm uses signals from the vehicle speed sensor to detect the actual gear position (1st, 2nd, 3rd or o/d gear). Then the ecm compares the actual gear with the shift schedule in the ecm memory to detect mechanical problems of the shift solenoid valves, valve body or automatic ...

Stuck in deceleration sensor
Description The skid control ecu receives signals from the yaw rate and deceleration sensor via the can communication system. The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (gl1: g sensor 1, gl2: g sensor 2). If there is t ...

© 2011-2026 Copyright www.trav4.net