Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Installation

  1. Install accelerator pedal rod

  1. Install the accelerator pedal rod with the 2 bolts.

Torque: 5.4 N*m (55 kgf*cm, 48 in.*Lbf)

  1. Connect the accelerator pedal position sensor connector.
  1. Connect cable to negative battery terminal

Toyota RAV4. Installation


Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

2Az-fe ignition
...

Other materials:

Check mode procedure
Description Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, dtcs are detected with 1 trip detection logic. Check mode pro ...

Air outlet damper control servo motor circuit
Description The damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the mode damper to the appropriate position, which controls the air o ...

Intuitive parking assist
The distance from your vehicle to nearby obstacles when parallel parking or maneuvering into a garage is measured by the sensors and communicated via the indicator and a buzzer. Always check the surrounding area when using this system. Types of sensors Rear corner sensors Rear center sen ...

В© 2011-2026 Copyright www.trav4.net