Toyota RAV4 (XA40) 2013-2018 Service Manual: Components (2005/11-2006/01)
Sliding roof ecu power source circuit
Description
If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ecu power source circuit.
Wiring diagram
Inspection procedure
- Perform active test by intelligent tester (sliding roof operation)
- Select the active test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.
Sliding roof ecu
Ok: sliding roof operates normally.
- Inspect fuse (s/roof, ecu-ig1)
- Remove the s/roof and ecu-ig1 fuses from the instrument panel junction block.
- Measure the resistance of the fuses.
Standard resistance:
below 1 
- Check wire harness (sliding roof drive gear - body ground)
- Disconnect the p6 drive gear connector.
- Measure the voltage and resistance of the wire harness side connector.
Standard voltage 
Standard resistance 
Replace sliding roof drive gear sub-assembly
Other materials:
Customize parameters
Hint:
The following items can be customized.
Notice:
When the customer requests a change in a function,
first make sure that the function can be customized.
Be sure to make a note of the current settings before
customizing.
When troubleshooting a function, first make sure that
the fu ...
Can communication system
Precaution
Precaution
Turn the ignition switch off before measuring the
resistance of the main wire and the branch wire.
After the ignition switch is turned off, check that the
key reminder warning system and light reminder
warning system are not in operation.
Before measuring th ...
Installation
Install starter assembly
Install the starter with the 2 bolts.
Torque: 37 n*m (377 kgf*cm, 27 ft.*Lbf)
Connect the starter connector.
Install the terminal nut and cover the nut with the
cap.
Torque: 9.8 N*m (100 kgf*cm, 7 ft.*Lbf)
Install battery bracket reinfor ...
