Toyota RAV4 (XA40) 2013-2018 Owners Manual: Power back door switch (vehicles with a power back door)
Pressing the switch closes the back door automatically. (A buzzer sounds.)
Pressing the switch while the back door is opening/closing stops the operation. Pressing the switch again will reverse the operation.
Opening the back door from outside the vehicle
Back door opener
Vehicles without a power
back door
Raise the back door while
pressing up the back door
opener switch.
Vehicles with a power back
door
When the back door is
unloc ...
When closing the back door
Lower the back door using the
back door handle.
Vehicles without a power back
door
Make sure to push the back door
down from the outside to close it.
Vehicles with a power back
door
...
Other materials:
Front speed sensor
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
Switch failure
Description
This dtc is output when the sliding roof drive gear (sliding roof ecu)
detects that the slide open or
tilt up switch in the overhead junction block is stuck for 30 seconds or more.
Wiring diagram
Refer to dtc b2341 (see page rf-11).
Inspection procedure
Read value of i ...
Hill-start assist control
When the engine is stopped by
the Stop & Start system when
the vehicle is on an incline,
when the brake pedal is
released, brake force is temporarily
maintained to prevent the
vehicle from rolling backwards
before the engine is restarted
and drive force is generated.
When drive force is generat ...
