Toyota RAV4 (XA40) 2013-2018 Owners Manual: Registering a bluetooth® audio player for the first time
To use the bluetooth® audio, it is necessary to register an audio player with the system.
Once the player has been registered, it is possible to use the bluetooth® audio.
For details about registering a bluetooth® device
- Turn the bluetooth® connection setting of your audio player on.
- Press the “audio” button.
- Select “
audio”. - Select “select device”.
- Follow the steps in “how to registering a bluetooth® device” from 2
Preparations to
use wireless
communication
The following can be performed using bluetooth® wireless communication:
A portable audio player can be operated and listened to via
audio system
Hands-free phone calls can be made via a cellu ...
Registering a bluetooth®
phone for the first time
To use the hands-free system, it is necessary to register a
bluetooth® phone with the system.
Once the phone has been registered, it is possible to use the
hands-free system.
For details abou ...
Other materials:
On-vehicle inspection
Connect intelligent tester
Connect the intelligent tester to the dlc3.
Start the engine and idle it.
Select the active test mode on the intelligent tester.
Hint:
Please refer to the intelligent tester operator's
manual for further details.
Check actuator motor operation
...
Removal (2005/11-2006/01)
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove roof headlining assembly
Remove the roof headlining (see page ir ...
Rear brake flexible hose
Installation
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Install rear brake tube flexible hose
Notice:
The gasket and union bolt must be used as a set, as
shown in the illustration.
Connect the flexible hose wi ...
