This vehicle belongs to the utility vehicle class, which has higher ground clearance and narrower tread in relation to the height of its center of gravity to make it capable of performing in a wide variety of off-road applications.
Utility vehicle feature
WARNING
â– Utility vehicle precautions
Always observe the following precautions to minimize the risk of death, serious injury or damage to your vehicle:
Failure to operate this vehicle correctly may result in loss of control or vehicle rollover causing death or serious injury.
Your vehicle (or any similar offroad vehicle) can tip over sideways much more easily than forward or backward.
Off-road driving
When driving your vehicle off-road, please observe the following precautions to ensure your driving enjoyment and to help prevent the closure of areas to off-road vehicles:
When conditions are wet, driving techniques should be changed or travel delayed to prevent damage to roads.
â– Additional information for offroad driving
For owners in U.S. mainland, Hawaii and Puerto Rico:
To obtain additional information pertaining to driving your vehicle offroad, consult the following organizations:
WARNING
â– Off-road driving precautions
Always observe the following precautions to minimize the risk of death, serious injury or damage to your vehicle:
This may cause loss of control or vehicle rollover causing death or serious injury. You are also risking expensive damage to your vehicle's suspension and chassis.
NOTICE
â– To prevent the water damage
Take all necessary safety measures to ensure that water damage to the engine or other components does not occur.
â– When you drive through water
If driving through water, such as when crossing shallow streams, first check the depth of the water and the bottom of the riverbed for firmness. Drive slowly and avoid deep water.
â– Inspection after off-road driving
Winter driving tipsDifferent diameter tire malfunction
Description
The skid control ecu measures the speed of each wheel by receiving signals
from the speed sensor.
These signals are used for recognizing that all 4 wheels are operating properly.
Therefore, all wheel
signals must be equal.
Inspection procedure
Check tire size
...
Open in pump motor circuit
Description
The motor relay drives the pump motor based on a signal from the skid control
ecu.
Wiring diagram
Refer to dtc c0273/13, c0274/14, c1361/91 (see page bc-79).
Inspection procedure
Perform active test by intelligent tester (motor relay)
Select the active test, gener ...
Turn signal light circuit
Description
The turn signal flasher relay (marking: flsh) in the main body ecu turns on
when it receives signals
from the headlight dimmer switch integrated with the turn signal switch, causing
the turn signal lights to
flash.
Wiring diagram
Inspection procedure
Check operation of t ...