Toyota RAV4 (XA50) 2019-2026 Owners Manual: Driving
- Before driving
- Driving the vehicle
- Cargo and luggage
- Vehicle load limits
- Trailer towing
- Towing related terms
- Weight limits
- Trailer Tongue Weight
- Trailer towing tips
- Dinghy towing
- Driving procedures
- Engine (ignition) switch (vehicles without smart key system)
- Engine (ignition) switch (vehicles with smart key system)
- Automatic transmission
- Turn signal lever
- Parking brake
- Brake Hold
- Operating the lights and wipers
- Headlight switch
- AHB (Automatic High Beam)
- Fog light switch
- Windshield wipers and washer
- Rear window wiper and washer
- Refueling
- Opening the fuel tank cap
- Toyota Safety Sense 2.5
- PCS (Pre-Collision System)
- Changing settings of the pre-collision system
- LTA (Lane Tracing Assist)
- Functions included in LTA system
- Indications on multi-information display
- RSA (Road Sign Assist)
- Dynamic radar cruise control with full-speed range
- Driving in vehicle-to-vehicle distance control mode
- Canceling and resuming the speed control
- BSM (Blind Spot Monitor)
- Blind Spot Monitor operation
- Intuitive parking assist
- Sensor detection display, object distance
- RCTA (Rear Cross Traffic Alert) function
- RCTA function
- PKSB (Parking Support Brake)
- Enabling/Disabling the Parking Support Brake
- Parking Support Brake function (static objects)
- Parking Support Brake function (rear-crossing vehicles)
- Stop & Start system
- Hill-start assist control
- Driving mode select switch
- Multi-terrain Select (AWD vehicles)
- Snow mode switch (AWD vehicles)
- Downhill assist control system
- Driving assist systems
- Driving tips
Panoramic moon roof
Use the overhead switches
to operate the panoramic
moon roof and electronic
sunshade.
Operating the electronic
sunshade and panoramic
moon roof
â– Opening and closing the
electronic sunshade
Opens ...
Before driving
...
Other materials:
Rear door courtesy switch
Components
Removal
Hint:
Use the same procedures for the rh and lh sides.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal t ...
Diagnostic trouble code chart
Hint:
If no abnormality is found when inspecting parts, check the
skid control ecu and check for poor contact at the ground
points.
If a dtc is displayed during the dtc check, check the
circuit for the dtc listed in the table below. For details of
each dtc, refer to the page indicated. ...
Diagnosis system
Description
Power door lock control system data can be read in the
data link connector 3 (dlc3) of the vehicle. When the
system seems to be malfunctioning, use the intelligent
tester to check for malfunctions and perform repairs.
Check dlc3
The ecu uses iso 15765-4 for communi ...
