Toyota RAV4 (XA50) 2019-2026 Owners Manual: Opening the fuel tank cap
- Toyota Safety Sense 2.5
- PCS (Pre-Collision System)
- Changing settings of the pre-collision system
- LTA (Lane Tracing Assist)
- Functions included in LTA system
- Indications on multi-information display
- RSA (Road Sign Assist)
- Dynamic radar cruise control with full-speed range
- Driving in vehicle-to-vehicle distance control mode
- Canceling and resuming the speed control
- BSM (Blind Spot Monitor)
- Blind Spot Monitor operation
- Intuitive parking assist
- Sensor detection display, object distance
- RCTA (Rear Cross Traffic Alert) function
- RCTA function
- PKSB (Parking Support Brake)
- Enabling/Disabling the Parking Support Brake
- Parking Support Brake function (static objects)
- Parking Support Brake function (rear-crossing vehicles)
- Stop & Start system
- Hill-start assist control
- Driving mode select switch
- Multi-terrain Select (AWD vehicles)
- Snow mode switch (AWD vehicles)
- Downhill assist control system
- Driving assist systems
Refueling
Opening the fuel tank cap
Perform the following steps
to open the fuel tank cap:
Before refueling the vehicle
Close all the doors and windows,
and turn the engine
switch to OFF.
Confirm the type ...
Toyota Safety Sense 2.5
The Toyota Safety Sense
2.5 consists of the following
drive assist systems and
contributes to a safe and
comfortable driving experience:
Driving assist system
PCS (Pre-Collision System)
LTA (Lane T ...
Other materials:
Installation (2005/11-2006/01)
Install abs and traction actuator assembly with bracket
Notice:
Do not remove the hole plug before connecting the
brake tube. New actuators are filled with brake fluid.
Install the actuator with bracket with the 3 nuts.
Torque: 19 n*m (194 kgf*cm, 14 ft.*Lbf)
Hint:
The nuts shou ...
Second brake piston
Components
Disassembly
Remove 2nd brake piston return spring sub-assembly
Place sst on the return spring and compress.
Using a screwdriver, pry out the snap ring.
Remove the piston return spring.
Inspect 2nd brake piston return spring sub-assembly (see page ax-223)
...
Installation (2005/11-2006/01)
Install front drive shaft assembly lh
Coat the spline of the inboard joint shaft with gear
oil.
Using a brass bar and hammer, align the shaft
splines in the drive shaft.
Notice:
Set the snap ring with the opening side facing
downwards.
Be careful not to damage the oil s ...
