Pictorial indexInstallation
(2005/11-2006/01)
Install front drive shaft assembly lh
Coat the spline of the inboard joint shaft with gear
oil.
Using a brass bar and hammer, align the shaft
splines in the drive shaft.
Notice:
Set the snap ring with the opening side facing
downwards.
Be careful not to damage the oil s ...
Inspection
Inspect starter assembly
Notice:
These tests must be performed within 3 to 5 seconds
to avoid burning out the coil.
Perform the pull-in test.
Disconnect the lead wire from terminal c.
Connect the battery to the magnetic switch as
shown in the illustration. Check that the clutch ...
Indicators
The indicators inform the driver
of the operating state of the
vehicle's various systems.
Turn signal indicator
Headlight indicator
Tail light indicator
Headlight high beam indicator
Automatic High Beam
indicator
Fog light indicator (if
equipped)
Smart key system indicator*
1
Cruise control ...