Toyota RAV4 (XA50) 2019-2026 Owners Manual: Vehicle status information and indicators
- Warning lights and indicators
- Gauges and meters (with 7- inch multi-information display)
- Gauges and meters (with 12.3-inch multi-information display)
- Multi-information display (with 7-inch multi-information display)
- Display contents
- Changing the display
- Driving information display
- Vehicle information display
- Settings display
- Multi-information display (with 12.3-inch multi-information display)
- Fuel consumption information
Alarm
The alarm uses light and
sound to give an alert when
an intrusion is detected.
The alarm is triggered in the
following situations when
the alarm is set:
Vehicles without smart key
system: A locked ...
Other materials:
Diagnosis system
Description
Air conditioning system data and the diagnostic
trouble codes (dtcs) can be read through the
data link connector 3 (dlc3) of the vehicle. When
the system seems to be malfunctioning, use the
intelligent tester to check for malfunctions and
perform troubleshooting.
...
Abs control system malfunction
Description
This dtc is output when the vsc system detects a malfunction in the abs
system.
Inspection procedure
Check dtc for abs system
Clear the dtc (see page bc-47).
Turn the ignition switch on.
Check if the same dtc is recorded (see page bc-47).
Result
Repair ...
Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit
listed for the dtc in the table below (refer to the appropriate
page).
Hint:
When the srs warning light remains on and the normal
system code is output, a decrease in the source voltage is
likely to occur. This malfunction is n ...
