Toyota RAV4 (XA50) 2019-2025 Owners Manual: Multi-information display (with 7-inch multi-information display)

Gauges and meters (with 12.3-inch multi-information display)

The meters display various drive information. Meter display â–  Locations of gauges and meters The meter type can be changed on of the multi-information display. Type 1/Type 2 The units of measure ...

Display contents

Following information is displayed on the multi-information display. Driving support system information Displays recognized signs while the RSA system (if equipped) is operating. Displays an image ...

Other materials:

Installation
Install ecm Install the 2 brackets to the ecm with the 4 screws. Torque: 3.0 N*m (30 kgf*cm, 27 in.*Lbf) Connect the 2 ecm connectors. Notice: When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and ...

Inspection
Inspect starter assembly Notice: These tests must be performed within 3 to 5 seconds to avoid burning out the coil. Perform the pull-in test. Disconnect the lead wire from terminal c. Connect the battery to the magnetic switch as shown in the illustration. Check that the clutch ...

Position initialization incomplete
Description This dtc is output when the sliding roof drive gear (sliding roof ecu) has not been initialized. Wiring diagram Refer to dtc b2341 (see page rf-11). Inspection procedure Initialize sliding roof drive gear sub-assembly (sliding roof ecu) Check that the sliding roof ...