â– Drive information
2 items that are selected using the "Drive Info Items" setting (average speed and distance) can be displayed vertically.
Use the displayed information as a reference only.
â– Trip information
2 items that are selected using the "TRIP A Items" or "TRIP B Items" setting (average speed and distance) can be displayed vertically.
Use the displayed information as a reference only.
*: To reset, display the desired item
and press and hold
.

Displays the drive status of each wheel in 6 steps from 0 to 5.
The illustration used is intended as an example, and may differ from the image that is actually displayed on the multi-information display.
Blank (No items)
Displays no drive information contents on the multi-information display.
Fuel Economy
Settings displayIgnition key cylinder light
Components
Removal
Disconnect cable from negative battery
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Place front wheels facing straight ahead
Remove steering pad ...
Changing settings of the
pre-collision system
â– Enabling/disabling the pre-collision
system
The pre-collision system can be
enabled/disabled on the
screen of the
multi-information display.
The system is automatically
enabled each time the engine
switch is turned to ON.
If the system is disabled, the
PCS warning light will turn on
and a mes ...
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the seat belt
warning system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
11 to 14 v
If the voltage is below 11 v, recharge or replace the battery
before proceeding.
...