Toyota RAV4 (XA50) 2019-2026 Owners Manual: Tires

Checking the battery

Check the battery as follows. â–  Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. Terminals Hold-down clamp ...

Checking tires

Check if the treadwear indicators are showing on the tires. Also check the tires for uneven wear, such as excessive wear on one side of the tread. Check the spare tire condition and pressure if not ...

Other materials:

Diagnosis system
Bus check Select "bus check" from the "obd / mobd menu" screen. Hint: The ecus and sensors that are properly connected to the can communication system can be displayed using the intelligent tester via can vim. Press "enter" on the intelligen ...

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
Preconditions The monitor will not run unless: The mil is off. Drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the tester on. Clear dtcs (if set) (see page es-35). Start the engine. Allow the engine to idle for 10 minute ...

Reassembly
Install evaporator temperature sensor Notice: If reusing the evaporator, do not insert the sensor to a location where the sensor was previously inserted. Insert the sensor within range c shown in the illustration. Install the evaporator temperature sensor as shown in the illustrati ...