Manual air conditioning systemSliding roof control switch circuit
Description
If either the sliding function or tilt function does not operate, there may
be a malfunction in the sliding roof
control switch circuit.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (sliding roof operation)
Select the active test, use ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Install rear stabilizer bush
Install the 2 bushes.
Hint:
Install each bush to the outer side of the bush
stopper on each stabilizer bar.
Install each bush with ...
Installation
Install ecm
Install the 2 brackets to the ecm with the 4 screws.
Torque: 3.0 N*m (30 kgf*cm, 27 in.*Lbf)
Connect the 2 ecm connectors.
Notice:
When connecting the connector, make sure that
dirt, water and other foreign matter does not
become stuck between the connector and ...