Toyota RAV4 (XA50) 2019-2025 Owners Manual: When trouble arises
- Essential information
- Emergency flashers
- If your vehicle has to be stopped in an emergency
- If the vehicle is submerged or water on the road is rising
- Steps to take in an emergency
- If your vehicle needs to be towed
- If you think something is wrong
- If a warning light turns on or a warning buzzer sounds
- If a warning message is displayed
- If you have a flat tire
- If the engine will not start
- If the electronic key does not operate properly (vehicles with smart key system)
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
Light bulbs
You may replace the following
bulbs by yourself. The
difficulty level of replacement
varies depending on
the bulb. If necessary bulb
replacement seems difficult
to perform, contact your
Toyota dealer. ...
Other materials:
Steering angle sensor zero point malfunction
Description
The skid control ecu learns the steering sensor zero point every time the
ignition switch is turned on and
the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds.
The ecu also stores the
previous zero point.
If front wheel alignment or the steering wh ...
Dtc check / clear
Check dtc (when using intelligent tester)
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignition switch on.
Turn the tester on.
Read the dtcs by following the prompts on the
tester screen.
Hint:
Refer to the intelligent tester operator's manual for
furth ...
Back door outside garnish
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove back door center garnish (see page
ed-5 ...
