If the engine will not start even though correct starting procedures are being followed, consider each of the following points:
The engine will not start even though the starter motor operates normally
One of the following may be the cause of the problem:
Refuel the vehicle.
Try to restart the engine again following correct starting procedures.
The starter motor turns over slowly, the interior lights and headlights are dim, or the horn does not sound or sounds at a low volume
One of the following may be the cause of the problem:
The starter motor does not turn over (vehicles with smart key system)
The engine starting system may be malfunctioning due to an electrical problem such as electronic key battery depletion or a blown fuse. However, an interim measure is available to start the engine.
The starter motor does not turn over, the interior lights and headlights do not turn on, or the horn does not sound
One of the following may be the cause of the problem:
Contact your Toyota dealer if the problem cannot be repaired, or if repair procedures are unknown.
Emergency start function (vehicles with smart key system)
When the engine does not start, the following steps can be used as an interim measure to start the engine if the engine switch is functioning normally:
1. Pull the parking brake switch to check that the parking brake is set.
Parking brake indicator will come on.
2. Shift the shift lever to P.
3. Turn the engine switch to ACC.
4. Press and hold the engine switch for about 15 seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may be malfunctioning.
Have the vehicle inspected by your Toyota dealer.
If you lose your keys
New genuine keys can be made by your Toyota dealer using the other key and the key number stamped on your key number plate.
Keep the plate in a safe place such as your wallet, not in the vehicle.
NOTICE
â– When an electronic key is lost (if equipped)
If the electronic key remains lost, the risk of vehicle theft increases significantly. Visit your Toyota dealer immediately with all remaining electronic keys that were provided with your vehicle.
If you have a flat tire
If the electronic key does
not operate properly (vehicles
with smart key system)Rear coil spring
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove rear wheel
Remove skid control sensor wire (for 2wd)
(see page bc-198)
Remove rear speed sensor lh (for 4wd) (see
page bc-205)
Disconnect ...
Customize parameters
Notice:
When the customer requests a change in a function,
first make sure that the function can be customized.
Make a note of the current settings before
customizing.
When troubleshooting a function, first make sure that
the function is set to the default setting.
Combination me ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove no. 1 Engine under cover
Remove front fender apron rh
Remove radia ...