Interior
For safe useCompressor circuit
Description
When the a/c switch is turned on, the magnetic clutch on signal is sent from
the air conditioning
amplifier. Then the mg clt relay turns on to operate the magnetic clutch.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (a/c mag clutch)
C ...
Reassembly
Install evaporator temperature sensor
Notice:
If reusing the evaporator, do not insert the sensor to
a location where the sensor was previously inserted.
Insert the sensor within range c shown in the
illustration.
Install the evaporator temperature sensor as shown
in the illustrati ...
Removal (2006/01- )
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove roof headlining assembly
Remove the roof headlining (see page ir ...