Toyota RAV4 (XA50) 2019-2026 Owners Manual: Before driving

Toyota RAV4 (XA50) 2019-2026 Owners Manual / For safety and security / For safe use / Before driving

Observe the following before starting off in the vehicle to ensure safety of driving.

Installing floor mats

Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet.

1. Insert the retaining hooks (clips) into the floor mat eyelets.

For safe use

2. Turn the upper knob of each retaining hook (clip) to secure the floor mats in place.

For safe use

Always align the marks A.

WARNING

■Before driving

Check that the floor mat is securely fixed in the correct place with all the provided retaining hooks (clips). Be especially careful to perform this check after cleaning the floor.

For safe use

With the engine stopped and the shift lever in P, fully depress each pedal to the floor to make sure it does not interfere with the floor mat.

For safe driving

For safe driving, adjust the seat and mirror to an appropriate position before driving. Correct driving posture Adjust the angle of the seatback so that you are sitting straight up and so that yo ...

Other materials:

Adjusting the open position of the back door (vehicles with a power back door)
The open position of the power back door can be adjusted. Open the back door, and adjust it to the desired position. Press and hold the power back door switch on the back door until the buzzer sounds 4 times. Luggage compartment light The luggage compartment light turns on when the back ...

Steering angle sensor circuit malfunction
Description The steering sensor signal is sent to the skid control ecu via the can communication system. When there is a malfunction in the can communication system, it is detected by the steering sensor zero point malfunction diagnostic function. Wiring diagram Inspection proce ...

Disassembly
Inspect oil pump assembly (see page ax-218) Remove clutch drum oil seal ring Remove the 2 clutch drum oil seal rings. Remove stator shaft assembly Using a t30 ''torx'' socket, remove the 11 bolts and stator shaft. Keep the gears in assembling order. Inspect clearan ...