Toyota RAV4 manuals

Toyota RAV4 (XA50) 2019-2025 Owners Manual: Correct use of the seat belts

For safe use


â– Child seat belt usage

The seat belts of your vehicle were principally designed for persons of adult size.

â– Seat belt extender

If your seat belts cannot be fastened securely because they are not long enough, a personalized seat belt extender is available from your Toyota dealer free of charge.

For safe use


WARNING

â– Using a seat belt extender

Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swerving or an accident.

Failure to do so may cause death or serious injury.

NOTICE

â– When using a seat belt extender

When releasing the seat belt, press on the buckle release button on the extender, not on the seat belt.

This helps prevent damage to the vehicle interior and the extender itself.

Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle. WARNING Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swer ...

Fastening and releasing the seat belt
To fasten the seat belt, push the plate into the buckle until a click sound is heard. To release the seat belt, press the release button A. â– Emergency locking retractor (ELR) The retractor wi ...

Other materials:

Pressure control solenoid "d" electrical (shift solenoid valve slt)
Description Refer to dtc p2714 (see page ax-91). Monitor description When an open or short in the shift solenoid valve slt circuit is detected, the ecm interprets this as a fault. The ecm will illuminate the mil and store the dtc. Monitor strategy Typical enabling conditions ...

Dtc check / clear
Check dtc (using sst (check wire)) Check the dtcs (present trouble code). Turn the ignition switch on, and wait for approximately 60 seconds. Using sst, connect terminals 13(tc) and 4(cg) of the dlc3. Sst 09843-18040 Notice: Connect the terminals to the correct positio ...

Reassembly
Install front oil pump oil seal Using sst and a hammer, install a new oil seal to the pump. Sst 09350-32014 (09351-32140) Hint: The seal end should be flat with the outer edge of the oil pump. Coat the lip of the oil seal with petroleum jelly. Install front oil pump bo ...

© 2011-2025 Copyright www.trav4.net