Toyota RAV4 (XA40) 2013-2018 Service Manual: Disassembly
Hint:
When removing the ornament plate and emblem, heat the radiator grille, ornament plate and emblem using a heat light.
Standard heating temperature
Notice:
Do not heat the radiator grille, ornament plate and emblem excessively.
- Remove hood to radiator grille seal
- Remove the double-sided tape.
- Detach the 7 clips and remove the hood to radiator grille seal.
- Remove no. 2 Radiator grille emblem
- Remove the 2 screws.
- Detach the claw and remove the emblem.
- Remove radiator grille ornament plate (for separate type)
- Remove the 12 screws and ornament plate.
- Remove radiator grille emblem
- Using a screwdriver, detach the 3 claws and remove the emblem from the radiator grille.
Hint:
Tape the screwdriver tip before use.
Notice:
- If reusing the emblem, take care not to damage the emblem.
- Be careful not to damage the emblem base.
Removal
Remove radiator grille sub-assembly
Remove the 4 bolts and 4 nuts.
Detach the 6 claws and remove the radiator grille.
Remove no. 1 Radiator grille lower
Detach the 1 ...
Reassembly
Hint:
When installing the ornament plate and emblem, heat the
radiator grille, ornament plate and emblem using a heat light.
Standard heating temperature
Notice:
Do not heat the radiator ...
Other materials:
Throttle / pedal position sensor / switch "A" circuit range / performance
problem
Hint:
This dtc relates to the throttle position (tp) sensor.
Description
Refer to dtc p0120 (see page es-114).
Monitor description
The ecm uses the tp sensor to monitor the throttle valve opening angle.
This sensor transmits two signals: vta1 and vta2. Vta1 is used to detect the
th ...
Input signal circuit abnormal
Description
This dtc expresses the internal abnormalities of the ecm.
Inspection procedure
Check for dtc
Clear the dtc (see page cc-15).
Check for dtc (see page cc-15).
Ok:
dtc is not output.
End ...
Brake pedal load sensing switch
Description
The brake pedal load sensing switch is turned on when the brake pedal is
depressed with force exceeding
a predetermined level.
The skid control ecu detects if the brake pedal is depressed or not via this
circuit.
Wiring diagram
Inspection procedure
Notice:
When repla ...
