Hood
ComponentsCheck 4wd control ecu (for 4wd)
Notice:
Turn the ignition switch off before measuring the
resistances of the main wire and branch wire.
After the ignition switch is turned off, check that the
key reminder warning system and light reminder
warning system are not in operation.
Before measuring the resistance, leave the ...
Driver side seat belt warning light does not operate
Description
When the ignition switch is on, the center airbag sensor transmits front seat
inner belt status signals to
the combination meter through the can bus line. If the driver seat belt is not
fastened, the combination
meter blinks the driver side seat belt warning light. If the seat bel ...
Emission control system
Parts location
System diagram
On-vehicle inspection
Check fuel cut rpm
Increase the engine speed to at least 3,500 rpm.
Use a sound scope to check for injector operating
noise.
Check that the operating sounds stop momentarily
and then resume when the t ...